Pinty Bullpup 1/2×20 Unf Shroud Adapter
1/2×20 unf shroud adapter machined for Pinty Bullpup. This will allow you to utilize any 1/2×20 moderator. Simple swap, does not require any modification. CNC machined from 6061 T6 and blk anodized. Made in the USA
Umarex Notos (Gen3/Non Threaded) 1/2×20 Unf Shroud Adapter
Shroud adapter made for the lastest generation Notos. These are slip fit instead of the original threaded version. It is CNC machined from 6061 and black anodized. Made right here in USA.
Air Venturi Avenger 1/2x20unf Shroud Adapter
Machined shroud adapter design for the AV Avenger. This adapter will allow you to use any 1/2x20unf moderator. Machined from 6061 T6 and blk anodized. Made in USA
Air Venturi Alpha (Compact) Shroud Adapter
AV Alpha (compact) front shroud adapter machined for use of aftermarket moderators with larger diameter than the factory one. This adapter will replace the factory one that doesn’t have enough clearance to run a larger aftermarket moderator. CNC machined from 6061 and blk anodized. Made in USA
Umarex Zelos Bottle Adapter
This is a bottle adapter machined to fit the Umarex Zelos. It’ll come with washer seal, shims and orings needed for the installation. You would use the M8 gauge from your factory air tube for the install. These are machined from 6061 T6 and blk anodized. Made in USA.
Umarex Notos Plenum Ext Tapped For 1/8 BSP
This is a plenum extension designed for the gen2 plenums that is drilled and tapped for 1/8 bspp gauge. It will come with the necessary orings, shims (to clock), and a 1/8 bspp gauge. The volume is 22cc and it’ll also add an additional 52mm of length. It is CNC machined from 6061 T6 and black anodized. Note: in order for this to fit you will need the main plenum (gen2) to attach it to. Step 1- Remove rear cover on main plenum Step 2- Attach the male end of the extension to the female end of the main plenum Step 3- Attach the rear cover you’ve removed from the main plenum to the rear female side of the extension